3. Adjust the edge feeding length
(1) Adjust the edge feeding length on the front end
Press the button(A), and key in the number. If customer wants to decrease the edge
feeding length, increase the number of the distance by the same degree.
For example, if the extra edge length on the front side is 20mm, and customer wants
to modify it to 15mm, that is, customer needs to increase the distance by 5mm. And
now assume the distance(A) is 670.0mm, so customer needs to increase to number
to 675.0mm (adjusted by the same 5mm degree).
(2) Adjust the edge feeding length on the rear end
Press the button(B), and key in the number. If customer wants to decrease the edge
feeding length, decrease the number of the cutting position too by the same degree.
For example, if the extra edge length on the rear side is 20mm, and customer wants
to modify it to 15mm, that is, customer needs to decrease the cutting position by
5mm. And now assume the cutting position(B) is 700.0mm, so customer needs to
decrease to number to 695.0mm (adjusted by the same 5mm degree).
To Next Page
