6.12 Fuses and motor breaker
Warning: Before doing any maintenance, disconnect power source and air input.
6.12.1 Replace fuses
Fuse specification listed on the machine.
6.12.2 Reset motor circuit breaker
Most typically, circuit breakers trip because a circuit is drawing too much current for the
amperage rating of the circuit breaker and the wired it feed. The best way to eliminate this
kind of tripping is to reduce the electrical load on the circuit and reset the breaker.
If over current happened for some reasons, make sure there is nothing stuck around the
motor, if so, remove it. Then reset breaker by pressing black button to reboot the machine
in 5 minutes.
To Next Page
