Cantek MX370M - End Trimming & Corner Rounding Unit; Replace Cutter

MAX370M
42
6.9 End trimming & Corner rounding unit
Warning: Before changing any blades, please press emergency stop and wait till the blades are
all stop!
6.9.1 Replace cutter
1. Loosen handle A and
remove connector.
2. Take off screw B then
remove motor set.
3. Remove nut
4. Change cutter
5. Put cutter back.
6. When assembling
back, need to make
sure their directions
are correct.
7. When assembling
motor set back,
remember to lock
screw B before
locking handle A.
A
Connector
B