Cantek MX370M - Buffing Unit Replacement; Pre-Milling Unit; Change Pre-Milling Cutters

MAX370M
41
6.7 Buffing unit replacement
Replace both buffing unit at the same time, that would stay better performance as production.
1. Hold the wheel and turn clockwise to remove the nut A and flange B.
2. Replace new one and reassemble.
6.8 Pre-milling unit
Warning: Before changing any blades, please press emergency stop and wait till the blades are
all stop!
6.8.1 Change pre-milling cutters
Note: Make sure the cutters’ directions are the same as following photo.
1. Remove screw A and B, then take off the cover.
2. Use the stopper to remove the nut and replace the cutters.
3. Reassemble them in right positions.
A
B
A
B
Stopper