8200-M585-O1 Rev D 210 Installation & Technical 96
DIGITAL FILL CONTROL ID STORAGE, CONT.
To Edit or View A DFC-ID Setting
1. With the indicator in normal operations mode, press the key. The display will change
FUnCt=, press the PRESET key.
2. Enter up to a 6-digit alphanumeric ID string and press the ENTER key.
3. SINGLE SPEED:
The display will show FiLL
=
, press the ENTER key. The current Fill weight will be
displayed, if the displayed weight is acceptable press the ENTER key, otherwise, use the
numeric keys to enter the new Fill weight and press ENTER.
TWO SPEED:
The display will show FASt
=
, press the ENTER key. The current FASt weight will be
displayed, if the displayed weight is acceptable press the ENTER key, otherwise, use the
numeric keys to enter the new FASt weight and press ENTER.
4. SINGLE SPEED:
Skip to step 5.
TWO SPEED:
The display will change to
SLo=
, press the ENTER key. The current SLO weight will be
displayed, if the displayed weight is acceptable press the ENTER key, otherwise, use the
numeric keys to enter the new SLO weight and press ENTER.
NOTE: The SLO weight MUST be greater than the FASt weight.
5. The display will change to show trin =, press the ENTER key and the current trim weight
will be displayed. If this value is acceptable press the ENTER key, otherwise, use the
numeric keys to enter a new trim weight and press the ENTER key.
6. The display will change to ACCU=, press the ENTER key to show the current accumulator
weight associated with this ID.
7. If the accumulator weight is correct, press the ENTER key to save it. Otherwise, using the
numeric keys enter the new accumulator value and then press the ENTER key to save it.
8. The display will change to CoUnt=, press the ENTER key to show the current count of
batches associated with this ID.
9. If the count is correct, press the ENTER key to save it. Otherwise, using the numeric keys
to enter a new count value and then press the ENTER key to save it.
10. The indicator will return to normal operation.
To Next Page
Loading...
Need help?
General
