8200-M585-O1 Rev D 210 Installation & Technical 23
KEYPAD FUNCTIONS, CONT.
oPEr= 1 ID Storage
This key initiates a weigh-in or weigh-out operation.
Press the Fn key and enter the ID at the id= prompt. To store/modify a permanent ID,
press the key followed by the Fn key, then enter the desired ID at the id= prompt.
oPEr= 2 Digital Fill Control
This key will start or pause a digital fill.
1. With the DFC in an idle state, press the Fn key to start the fill.
2. While filling, press the Fn key to pause the fill.
3. While paused, press the Fn key to resume or abort the fill. The indicator will prompt
whether or not to continue filling (cont= yes/no).
If the DFC is setup for manual dumping, press the Fn key to initiate a dump after a fill is
completed.
oPEr= 6 Livestock Weigher
This key will allow you to input a head count (CoUnt=) for the next ticket to be printed.
Once prompted, press the ENTER key to display the current head count. Use the numeric
keys to select the new head count (1-255) and then press the ENTER key to accept it. The
value you entered will appear on the next ticket that is printed.
TIME/DATE KEY
This key is used to enter the clock mode to program the time, date and consecutive number.
Pressing the TIME/DATE key will enter the clock mode with the 210 displaying HoUr=.
12-Hour Format Selected In Setup (td=12)
1. With the display showing HoUr=, press the ENTER key.
2. If the time displayed is correct, press the ENTER key and proceed to step 4.
3. If the displayed time is incorrect, use the numeric keys to enter the correct time and
press the ENTER key.
4. The display will change to A=. Press the ENTER key.
5. The display will show YES.
If the time is before noon (12:00 PM), press the ENTER key.
If the time is after noon (12:00 PM), press the 0/NO key, then press the ENTER key.
6. The display will show dAtE=. Press the ENTER key.
7. If the date displayed is correct, press the ENTER key to proceed to the consecutive
number prompt, CnC n=.
8. If the date displayed is incorrect, use the numeric keys to enter the correct date and
press the ENTER key to proceed to the consecutive number prompt. Remember to
enter the date in the same format (month-day-year or day-month-year) as selected by
the USA setup parameter. Note that with the USA=YES setting, the date format is
month-day-year.
To Next Page
Loading...
