8200-M585-O1 Rev D 210 Installation & Technical 28
KEYPAD FUNCTIONS, CONT.
(ASTERISK) KEY
This key is used for several functions. During Setup, when a setup parameter (not a
parameter value) is displayed, pressing it key will "backup" to the previous prompt.
In normal operation, pressing the key will display FUnCt=. Pressing the associated key
listed below will enable additional features. These features and their associated key
combinations are as follows:
AND ZERO/REVIEW KEY
This combination will enter the Review mode of Setup and Calibration. Refer to
Setup Review section of this manual for details.
AND NET/GROSS KEY
This combination will display the Net accumulator.
AND NET/GROSS KEY, PRINT KEY
This combination will print the Net accumulator.
AND NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Net accumulator.
AND NET/GROSS KEY, NET/GROSS KEY
This combination will display the Gross accumulator.
AND NET/GROSS KEY, NET/GROSS KEY, PRINT KEY
This combination will print the Gross accumulator.
AND NET/GROSS KEY, NET/GROSS KEY, ZERO KEY
This combination will zero (clear) the Gross accumulator.
AND UNITS KEY
This combination will enter the Test mode. The Test mode is used to test of all the
display elements. It consists of five (5) cycles, each lasting about one (1) second:
1. All horizontal segments will turn on (no annunciators).
2. All vertical segments and decimal points will turn on (no annunciators).
3. All annunciators will turn on.
4. All display elements off.
5. The model number (210) and the software version X.X.
6. The calibration numbers (C1 to C4).
AND PRINT KEY
This combination is used to change the selected print ticket format. Pressing the
key then the PRINT key will display a prompt “Prt=”. Press the ENTER key to show
the current value. If the setting displayed is acceptable, press the ENTER key again
to save it. Otherwise, using the numeric keys enter the new setting, then press the
ENTER key to save it. Allowable values are:
0 = print tab settings 1 = visual ticket format 1 2 = visual ticket format 2
In addition to using the key, PRINT key combination to change the print ticket
format, the operator (just prior to printing the ticket) can change the print ticket format
at the end of the weighing operation. This is accomplished by performing the normal
weighing operation, then pressing the desired format number (0, 1 or 2), followed by
pressing the PRINT key.
NOTE: When a print format is selected (by either method), it will remain active
until changed by the operator.
To Next Page
Loading...
Need help?
General
