8200-M585-O1 Rev D 210 Installation & Technical 42
SETUP AND CALIBRATION, CONT.
Dual-Point with Zero (First Zero) Calibration
CAL1= – First Calibration Weight
The display will show CAL1=0. This is the first of two calibration weights. This weight
could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
If the first calibration weight is to be ZERO (NO LOAD), press the ENTER key.
If the first calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
numeric keys to input the value of the calibrated test weights. NOTE: When entering
values for CAL1=, the digits start displaying on the right side of the display and
proceed to the left. When large values are used (more than 3 digits), the CAL1=
prompt will automatically scroll off the left side of the display to show the additional
digits on the right as they are entered.
Place the weights on the scale platform, then press the ENTER key.
Starting at the left and advancing right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: CAL2=.
CAL2= - Second Calibration Weight
The display will show CAL2=0. This is the second of two calibration weights. This
weight could be ZERO (NO LOAD) or the TEST WEIGHTS / TEST LOAD.
If the second calibration weight is to be ZERO (NO LOAD), press the ENTER key.
If the second calibration weight is to be the TEST WEIGHTS / TEST LOAD, use the
numeric keys to input the value of the calibrated test weights. NOTE: When entering
values for CAL2=, the digits start displaying on the right side of the display and
proceed to the left. When large values are used (more than 3 digits), the CAL2=
prompt will automatically scroll off the left side of the display to show the additional
digits on the right as they are entered.
Place the weights on the scale platform, then press the ENTER key.
Starting at the left and advancing right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the display
will show: Sio?.
To Next Page
Loading...
Need help?
General
