8200-M585-O1 Rev D 210 Installation & Technical 80
ID STORAGE OPERATION, CONT.
Permanent Identification (ID) Strings
To Add A Permanent ID String
1. With the indicator in normal operations mode, press the key. The display will change
FUnCt=, press the Fn key.
2. Enter up to a 6-digit alphanumeric ID string and press the ENTER key.
3. The display will show tArE=, press the ENTER key. A 0 stored tare weight will be
displayed, if the displayed weight is acceptable press the ENTER key, otherwise, use the
numeric keys to enter the new tare weight and press ENTER, or press the NET key to
store the current Gross weight as the new stored tare weight.
4. The display will change to ACCU=, press the ENTER key to show a zero value for the
accumulator associated with this ID.
5. If a zero value is correct, press the ENTER key to save it. Otherwise, using the numeric
keys enter the accumulator value and then press the ENTER key to save it.
6. The display will change to LoAdS=, press the ENTER key to show a zero value for the
number of loads associated with this ID.
7. If a zero value is correct, press the ENTER key to save it. Otherwise, using the numeric
keys enter the number of loads and then press the ENTER key to save it.
8. The indicator will return to normal operation.
To Edit or View A Permanent ID String
1. With the indicator in normal operations mode, press the key. The display will change
FUnCt=, press the Fn key.
2. Enter up to a 6-digit alphanumeric ID string and press the ENTER key.
3. The display will show tArE=, press the ENTER key. The stored tare weight will be
displayed. If the displayed weight is acceptable press the ENTER key, otherwise, use the
numeric keys to enter the new tare weight and press ENTER, or press the NET key to
store the current Gross weight as the new stored tare weight.
4. The display will change to ACCU=, press the ENTER key to show the current accumulator
weight that is associated with this ID.
5. If the accumulator value is correct, press the ENTER k
ey to save it. Otherwise, using the
numeric keys enter a new accumulator value and then press the ENTER key to save it.
6. The display will change to LoAdS=, press the ENTER key to show the current number of
loads that are associated with this ID.
7. If the number of loads is correct, press the ENTER key to save it. Otherwise, using the
numeric keys enter the new number of loads and then press the ENTER key to save it.
8. The indicator will return to normal operation.
To Next Page
Loading...
Need help?
General
