8200-M698-O1 Rev B 225 Installation and Technical
53
CALIBRATION AND SETUP, CONT.
With the PRINTR CONTINUOUS OUTPUT SELECTION menu displayed the current
setting for the TOLEDO Format= parameter will be shown. Note that X is the
current value. If the setting displayed is acceptable, press the ENTER key to save the
new setting and return to the COM0 SETUP MENU.
Otherwise, using the numeric keys, enter the value for the TOLEDO Format and then
press the ENTER key to save the new setting and return to COM0 SETUP MENU.
Allowable values are 0, 1, 2, or 3.
7. SCALE=X (SCALE USED FOR COM0 DATA)
With the COM0 SETUP MENU displayed the current setting for the SCALE=
parameter will be shown. Note that X is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
value for the scale for continuous data output and then press the ENTER key to save
the new setting and return to the COM0 SETUP MENU. Allowable values are 0 through
5. NOTE: Scale 1 is the default setting. Also note, 4 is the Scale Totalizer.
0 = Current Scale 3 = Scale 3
1 = Scale 1 4 = Total
2 = Scale 2
5 = All Scales (TYPE = 5 = SB500 or 6 = SB250/500M)
8. Gross Only=XXX (GROSS WEIGHT ONLY OUTPUT TO COM PORTS)
With the COM0 SETUP MENU displayed the current setting for the
Gross Only= parameter will be shown. Note that XXX is the current value. If the
setting displayed is acceptable, press EXIT (Navigation Keys UP Arrow) to return to
the Serial Menu.
Otherwise, press the 8 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the COM0 SETUP MENU.
Gross Only=YES Gross Only=NO
GROSS weight is transmitted on all
COM ports.
Displayed weight is transmitted on
all COM ports.
NOTE: If you selected 5. SB500 or 6. SB250/500M for the TYPE=
parameter, the following setup parameters Manual Mode= and Thres
Wt= will be shown on the COM0 SETUP MENU.
To Next Page
Loading...
