8200-M698-O1 Rev B 225 Installation and Technical
54
CALIBRATION AND SETUP, CONT.
9. Manual Mode=XXX (MANUAL LIGHT MODE)
With the COM0 SETUP MENU displayed the current setting for the
Manual Mode= parameter will be shown. Note that XXX is the current value. If the
setting displayed is acceptable, press EXIT (Navigation Keys UP Arrow) to return to
the Serial Menu.
Otherwise, press the 9 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the COM0 SETUP MENU.
Manual Mode=YES Manual Mode=NO
Manual Mode is Enabled. Pressing
START/STOP key will toggle traffic
light between Green and Red.
Manual Mode is Disabled.
Threshold weight is used to toggle
light between Green and Red.
10. Thres Wt=XXXXXXX (THRESHOLD WEIGHT FOR AUTO MODE)
With the COM0 SETUP MENU displayed the current setting for the Thres Wt=
parameter will be shown. Note that XXXXXXX is the current value. If the setting
displayed is acceptable, press EXIT (Navigation Keys UP Arrow) to return to the
Serial Menu.
Otherwise, press the 1 and 0 keys, the ENTER key and then using the numeric keys,
enter the value for the threshold weight
1
used to control the traffic light auto mode and
then press the ENTER key to save the new setting and return to the COM0 SETUP
MENU. Note that entering 0 disables the traffic light auto mode.
1
If scale gross weight is less than or equal to threshold weight, traffic light will be Green.
When scale gross weight is greater than threshold weight, traffic light will be Red.
NOTE: If manual light mode is disabled (Manual Mode=NO) and 0 is entered
for the threshold weight (Thres Wt=0), the traffic light feature will be disabled
(turned off).
COM0 Setup Completed
The COM0 setup has been completed, press EXIT (Navigation Keys UP Arrow) to return to
the Serial Menu and proceed to the COM port (serial port) setup.
To Next Page
Loading...
