Cardinal 225 - Page 63

8200-M698-O1 Rev B  225 Installation and Technical
55
CALIBRATION AND SETUP, CONT.
Serial Menu
1. COM0
2. COM1
3. COM2
4. COM3
Enter Selection: 0 ^ EXIT
2. COM1 (COM1, SERIAL PORT 1)
With the Serial Menu displayed, press the 2 key and then the ENTER key to proceed to the
COM1 SETUP MENU.
COM1 SETUP MENU
1. BAUD=X XXXXXX 6. TYPE=X XXXXXXXXXX
2. PARITY=X XXXX 7. SCALE=0
3. BITS=
4. STOPS=X
5. CONT=XXX
Enter Selection: 0 ^ EXIT
1. BAUD=X XXXXXX (COM1 BAUD RATE)
With the COM1 SETUP MENU displayed the current setting for the BAUD= parameter
will be shown. Note that X is the current value and XXXXXX is the actual baud rate. If
the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 1 key, the ENTER key and then using the numeric keys, enter the
value for the COM0 port baud rate and then press the ENTER key to save the new
setting and return to the COM1 SETUP MENU. Allowable values are 0 through 13.
0 = 300 4 = 4800 8 = 28800 12 = 115200
1 = 600 5 = 9600 9 = 38400 13 = 230400
2 = 1200 6 = 14400 10 = 57600
3 = 2400 7 = 19200 11 = 76000
The following describes the setup for the 225 COM ports (Serial Ports).
Although the three (3) COM ports can be configured differently, they have the
same setup parameters. In the setup menus shown and parameters described,
COM1 (Serial Port 1) is referenced. Substitute the COM port number you are
configuring for the number shown.