Cardinal 225 - Page 64

To Next Page

To Previous Page

8200-M698-O1 Rev B  225 Installation and Technical

CALIBRATION AND SETUP, CONT.

2. PARITY=X XXXX (COM1 PARITY RATE)

With the COM1 SETUP MENU displayed the current setting for the PARITY=

parameter will be shown. Note that X is the current value and XXXX is the description.

If the setting displayed is acceptable, proceed to the next setup parameter.

Otherwise, press the 2 key, the ENTER key and then using the numeric keys, enter the

value for the COM0 parity rate and then press the ENTER key to save the new setting

and return to the COM1 SETUP MENU. Allowable values are 0, 1 or 2.

0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity

3. BITS=X (COM1 DATA BITS)

With the COM1 SETUP MENU displayed the current setting for the BITS= parameter

will be shown. Note that X is the current value. If the setting displayed is acceptable,

proceed to the next setup parameter.

Otherwise, press the 3 key, the ENTER key and then using the numeric keys, enter the

value for the COM0 data bits and then press the ENTER key to save the new setting

and return to the COM1 SETUP MENU. Allowable values are 7 or 8.

4. STOPS=X (COM1 STOP BITS)

With the COM1 SETUP MENU displayed the current setting for the STOPS=

parameter will be shown. Note that X is the current value. If the setting displayed is

acceptable, proceed to the next setup parameter.

Otherwise, press the 4 key, the ENTER key and then using the numeric keys, enter the

value for the COM0 stop bits and then press the ENTER key to save the new setting

and return to the COM1 SETUP MENU. Allowable values are 1 or 2.

5. CONT=XXX (COM1 CONTINUOUS OUTPUT)

With the COM1 SETUP MENU displayed the current setting for the CONT= parameter

will be shown. Note that XXX is the current value. If the setting displayed is

acceptable, proceed to the next setup parameter.

Otherwise, press the 5 key, the ENTER key, YES or NO (on the soft keys) and then the

ENTER key to save the new setting and return to the COM1 SETUP MENU.

CONT=YES CONT=NO

Continuous Output Enabled Continuous Output Disabled

Other manuals for Cardinal 225