8200-M698-O1 Rev B 225 Installation and Technical
64
CALIBRATION AND SETUP, CONT.
TABS SETTING (General Format Information)
The general format for the input is A = YY.XX.
Where:
A is the character identifying the data printed
YY is the number of lines down
XX is the number of spaces to the right.
NOTE: Enter 00 in either location, YY or XX, to disable the
data from printing.
6. TIME=YY.XX (TIME PRINT LOCATION)
With PRINT TABBING MENU #1 displayed the current setting for the TIME=
parameter will be shown. Note that YY.XX is the current position for printing of the time.
If the position displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 6 key, the ENTER key and then using the numeric keys, enter the
new print position and then press the ENTER key to save the new setting and return to
PRINT TABBING MENU #1.
7. DATE=YY.XX (DATE PRINT LOCATION)
With PRINT TABBING MENU #1 displayed the current setting for the DATE=
parameter will be shown. Note that YY.XX is the current position for printing of the date.
If the position displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
new print position and then press the ENTER key to save the new setting and return to
PRINT TABBING MENU #1.
8. CNC NO=YY.XX (CONSECUTIVE NUMBER PRINT LOCATION)
With PRINT TABBING MENU #1 displayed the current setting for the CNC NO=
parameter will be shown. Note that YY.XX is the current position for printing of the
consecutive number. If the position displayed is acceptable, proceed to the next setup
parameter.
Otherwise, press the 8 key, the ENTER key and then using the numeric keys, enter the
new print position and then press the ENTER key to save the new setting and return to
PRINT TABBING MENU #1.
To Next Page
Loading...
