9
pGD Touch +030221540 rel. 1.1 - 21.01.2015
ENG
2. STRUCTURE
2.1 pGD Touch structure
The terminal’s front panel houses the display and signal LED.
During normal operation, users can manage and supervise the various
processes, browse screens and enter values by touching the keys on the
touchscreen keypad that is displayed for this purpose.
On the side are the gasket, slots for mounting the terminals, an SD card
slot and remote keypad connector (available on request).
On the rear is the product identification label and the PE terminal for the
electrical panel earth connection.
At the bottom or rear are the power connector, RS485 and Ethernet ports
for terminal network connection, and the USB port.
The drawings refer to the most complete models.
A
B
C
B
G
D
E
F
H
I
O
P
L
R
N
Fig. 2.a
D
C
N
E
M
G
I
H
L
S
R
A
B
Fig. 2.b
A
D
E
G
L
H
E
B
R
Fig. 2.c
4,3"
7"
10" - 13"
I Ethernet port 2
L RS485 port 1
M RS485 port 2
N Membrane keypad connector
O Ethernet port green status LED
P Ethernet port yellow status LED
Q AUX port (not active)
R Gasket
S Reserved
Key
A Signal LED (green/red)
B Mounting slots
C SD card slot
DPE
E Power connector
F Optically-isolated open collector output (model PGDT04000F020
only)
G USB Port
H Ethernet 1 Port
To Next Page
Loading...
