Appendix C: RTU Open Points/Properties on the Equipment Touch
RTU Open v3 CARRIER CORPORATION ©2019
Installation and Start-up Guide All rights reserved
104
Performance - Equipment Touch
– RTU Open's hours of operation since the last reset of
.
R: __ hr
– Percentage of
hours that are above the
active Economizer time since the last reset of
.
R: 0 to 100%
– Percentage of
hours that are above the active
DCV time since the last reset of
.
R: 0 to 100%
Unocc Free Cool Utilization
– Percentage of
hours that are above
active Unoccupied Free Cooling since the last reset of
.
R: 0 to 100%
Part Load Cooling Utilization
– Percentage of
hours that are above
Cooling time in which less than the maximum configured cooling stages were active
since the last reset of
.
R: 0 to 100%
Full Load Cooling Utilization
– Percentage of
hours that are above
Cooling time in which all of the configured cooling stages were active since the last
reset of
.
R: 0 to 100%
– Percentage of
hours that are above active
Heating time since the last reset of
.
R: 0 to 100%
– Maximum recorded OAT since the last reset of
.
R: __°F/C
– Minimum recorded OAT since the last reset of
. R: __°F/C
Click for
.
Click or for
.
– Indicates if the safety chain circuit trips. R: Normal/Alarm
To Next Page
Loading...
Need help?
General
