24
problem, it will default the measurements into equal sizes, with 10% leakage, and
display the zone number for the suspected zone damper.
NOTE: The daily duct assessment will occur even if static pressure monitoring is
disabled. This is done to ensure that the system will continue to provide proper
airflow for all installed equipment, since duct system changes may occur at any
time, such as opened or closed registers.
After the duct assessment is complete, touch NEXT.
A12186
6. Service Menu
The Service menus contain a set of vital information. This information enables the
installer or service person to view a summary of what has been installed, etc. This
information is not covered in the Owner’s Manual.
To enter service menus, touch menu, then touch and hold the SERVICE icon for at
least ten seconds. The following screens are available in installation and service. To
return to the previous screen, touch BACK. To exit the Service menus, touch
DONE.
NOTE: See the Owner’s Manual for information regarding software upgrades.
To Next Page
Loading...
Need help?
General
