Refresh Sequence (Free Format Text, 9)
This field is optional. It may contain embedded control characters. This
string will be sent to the service whenever the service is selected
(excluding initial connection).
CR/LF mapping (Constrained List)
Four fields are provided to select CR and LF character mapping to and from
X.25. Each field can be set to one of the following settings.
CR - map to CR
LF - map to LF
CR LF - map to the sequence CR LF
CR NULL - map to the sequence CR NULL
CR NULL LF - map to the sequence CR NULL LF
NOTHING - map to NOTHING
Service will Echo (Constrained List)
This field selects whether an Echo option is negotiated by TELNET.
YES – TELNET Echo option negotiated
NO – TELNET Echo option not used
Suppress Go-Ahead (Constrained List)
This field selects whether a Suppress Go-Ahead TELNET option is sent. It
is only used when the service connection is on the LAN.
SUPPRESSED – Enable the use of Suppress Go-Ahead.
NOT SUPPRESSED – Disable the use of Suppress Go-Ahead.
Binary (Constrained List)
This field selects whether the TELNET Binary option should be
negotiated. It is only used when the service is on the LAN. With Binary
mode enabled, the connection is requested to use a full 8-bit data path.
With Binary mode disabled, standard TELNET ASCII connection (7-bit
data path) is established.
ENABLED – TELNET Binary option negotiated
DISABLED – TELNET Binary option not used
Local X.3 Parameters (Constrained List)
This field selects whether the local X.3 parameters are used when
processing packets.
ENABLED - Process packet using X.3 parameters
DISABLED - Ignore X.3 parameters and forward packet immediately
X870-300351 Issue 1 4-22 Rev.0
To Next Page
