Casio TE-7000S - How to Initialize the Terminal (Add; Replace One Terminal; How to Flag Clear the Terminal (or INIT2

P-11
TE-7000S/8000F/8500F Programming Manual
1-2. How to initialize the terminal (add / replace one terminal)
Preparation:
1. All peripheral devices and terminals of this cluster should be
turned off.
2. Connect all of the peripheral devices (such as printer, display
etc.) to this terminal.
3. Connect the added / replaced terminal to inline.
Operation:
Follow the steps shown on the page 8 to 10.
1-3. How to flag clear the terminal (or INIT2)
Preparation:
1. All peripheral devices and this terminal should be turned off.
2. Check the connection of all peripheral devices (such as
printer, display etc.) of this terminal.
3. Check the connection of this terminal to inline.
Operation:
4. Turn on all peripheral devices of this terminal.
5. Turn on this terminal with pressing the “Receipt feed” key
and release the key after the “Copyright” window is shown.
6. After releasing the key, press the <ST> key.
7. Select “1. Flag Clear” and press the <YES> key.
The flag clear operation is finished.
Note:
Performing “Init 2” requires password “8888888888” and <YES>.
INIT
1.Flag Clear
2.Init2
0.00