P-98
Program 3
4-2-5-3 Programming mode control by range
Operation
5. Select “3. Mode Control” and press the <YES> key.
6. Select an appropriate record and choose options.
7. After programming, press the <ESC> key to proceed to the
next step.
8. Enter the start range No. and press the <YES> key.
(It starts “0001” if you skip to enter the start range.)
Then enter the end range No. and press the <YES> key.
(It ends the last record if you skip to enter the end range.)
9. Press the <YES> key.
10. Press the <ESC> key to return to the previous menu.
Mode Control
Allow to operate REG Mode YES
Allow to operate RF Mode YES
Allow to operate REG- Mode YES
Allow to operate PGM1 Mode YES
Allow to operate PGM2 Mode YES
Allow to operate PGM3 Mode YES
Allow to operate PGM4 Mode YES
Allow to operate PGM5 Mode YES
Allow to operate PGM6 Mode YES
Allow to operate X/Z Mode YES
Allow to operate Manager Mode YES´
0.00
Mode Control
Allow to operate PGM2 Mode YES¨
Allow to operate PGM3 Mode YES
Allow to operate PGM4 Mode YES
Allow to operate PGM5 Mode YES
Allow to operate PGM6 Mode YES
Allow to operate X/Z Mode YES
Allow to operate Manager Mode YES
Allow to operate Inline Mode YES
Allow to operate AUTO PGM YES
Allow to operate CF Card YES
Default mode after sign on REG
0.00
Range
Operation
1.Clerk Control
2.Menu Shift/2nd@
3.Mode Control
4.Allowed function 1
5.Allowed function 2
6.Allowed function 3
7.Allowed function 4
8.Allowed function 5 ´
0.00
Mode Control
Enter Start range 0
End range 0
OK? YES
0.00
Mode Control
Enter Start range 1
End range 99
OK? YES
0.00
To Next Page
Loading...
Need help?
General
