CG VSR239p5 - Group C1 Digital Output

Emotron VS Series Quick Start Guide
- 54 -
control mode
1: Two-wire mode 2
2: Three-wire mode 1
3: Three-wire mode 2
C0.16
Terminal UP/DOWN
frequency adjustment
control
Unit's place: action when stop
0: Clear
1: Holding
00001
×
Ten’s place: action on power loss
0: Clear
1: Holding
Hundreds place: integral function
0: No integral function
1: Integral function enabled
Thousand’s place: Select if it can be
reduced to negative frequency
0: Disable
1: Enable
Ten thousand’s place: Jog action to
clear UP/DOWN
0: Not Clear
1: Clear
C0.17
Terminal UP/DOWN
frequency change step
size
0.00～50.00Hz 0.00:Disabled
1.00Hz/
200ms
△
C0.18
Terminal action selection
when power on
0: Level effective
0
×
1: Edge trigger +Level
effective(When power on)
2: Edge trigger +Level
effective(Every start)
C0.19
Delay time before terminal
DI1 is invalid
0.0～300.0s
0.0s
△
C0.20
Delay time before terminal
DI2 is invalid
0.0～300.0s
0.0s
△
Group C1 Digital Output
C1.00
Y1 output function
00: No output
01: Running signal
02: Fault output
03: Frequency-level detection
FDT1 output
04: Frequency-level detection
FDT2 output
05: Drive in 0Hz running 1(no
output at stop)
06: Drive in 0Hz running 2(output
at stop)
07: Upper limit frequency attained
08: Lower limit frequency attained
09: Frequency attained
10: Inverter is ready to work
11: Drive (motor) overloaded alarm
12: Inverter overheat warning
13: Current running time attained
14: Accumulative power-on time
attained
15: Consecutive running time
attained
16: PLC cycle completed
17: Set count value attained
1
×
C1.01
Y2 output function
(VSX Only)
3
C1.02
Relay 1 output function
2
×
C1.03
Relay 2 output function
(VSX Only)
11
×