ii
IMPORTANT SAFETY INSTRUCTIONS:
SAVE THESE INSTRUCTIONS
Product Disposal
Do not dispose of as part of unsorted domestic waste. Inquire with local authorities regarding proper
disposal. Product materials are recyclable as marked.
No Accuracy Guarantee
Commercially reasonable efforts were made to ensure that the specifications and other information in this
manual are accurate and complete at the time of its publication. However, the specifications and other information in this
manual are subject to change at any time without prior notice.
Copyright and Trademarks
©2013-2019 ChargePoint, Inc. All rights reserved. This material is protected by the copyright laws of the United States and
other countries. It may not be modified, reproduced or distributed without the prior, express written consent of ChargePoint,
Inc. CHARGEPOINT is a U.S. and European Union registered trademark and service mark of ChargePoint, Inc. and cannot be
used without the prior written consent of ChargePoint.
WARNING:
1. Read and follow all warnings and instructions before installing and operating the ChargePoint® Charging
Station. Install and operate only as instructed. Failure to do so may lead to death, injury, or property damage,
and will void the Limited Warranty.
2. Only use licensed professionals to install your ChargePoint® Charging Station and adhere to all national
and local building codes and standards. Before installing the ChargePoint® Charging Station, consult with a
licensed contractor, such as a licensed electrician, and use a trained installation expert to ensure compliance
with local building and electrical codes and standards, climate conditions, safety standards, and all applicable
codes and ordinances. Inspect the Charging Station for proper installation before use.
3. Always ground the ChargePoint® Charging Station. Failure to ground the Charging Station can lead to risk
of electrocution or fire. The Charging Station must be connected to a grounded, metal, permanent wiring
system, or an equipment grounding conductor shall be run with circuit conductors and connected to the
equipment grounding terminal or lead on the Electric Vehicle Supply Equipment (EVSE). Connections to the
EVSE shall comply with all applicable codes and ordinances.
4. Install the ChargePoint® Charging Station on a concrete pad using a ChargePoint approved method.
Failure to install on a surface that can support the full weight of the Charging Station can result in death,
personal injury, or property damage. Inspect the Charging Station for proper installation before use.
5. This Charging Station is not suitable for use in hazardous locations.
6. This device should be supervised when used around children.
7. Do not put fingers into the electric vehicle connector.
8. Do not use this product if the flexible power cord or EV cable is frayed, has broken insulation, or any other
signs of damage.
9. Do not use this product if the enclosure or the EV connector is broken, cracked, open, or shows any other
indication of damage.
10. Use 75°C or 90°C wire copper conductors only.
Important: Under no circumstances will compliance with the information in this manual relieve the user of his/
her responsibility to comply with all applicable codes or safety standards. This document describes the most
commonly-used installation and mounting scenarios. If situations arise in which it is not possible to perform an
installation following the procedures provided in this document, contact ChargePoint, Inc. ChargePoint, Inc. is
not responsible for any damages that may result from custom installations that are not described in this
document or for any failure to adhere to installation recommendations.
To Next Page
Loading...
