EasyManua.ls Logo

ChargePoint CT4000 - Start Test Charging Session

ChargePoint CT4000
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
15. Enter the PIN code on the charging station.
16. Tap Done on the mobile page.
17. The installation wizard proceeds to perform a network test. When complete, press Continue
until you exit the installation wizard.
Start a Charging Session
Once the installation wizard is complete, use the ChargePoint app to start a test session. Verify that
you can:
• Initiate a charging session
• Unlock the holster and pull out the charge handle
• Plug the handle into the emulator (if available)
• Holster the handle
• Verify that the handle is locked again