11
3
Install a Wall Mount CT4000
Gather Required Tools
You need:
• Ratchet and 15 mm (9/16 in) deep socket
• #2 and #3 Phillips screwdrivers
• Flathead screwdriver
• Tape measure
• Level
• Marker
• Wire stripper
• Wire cutter
• Voltage tester
• Drill and tap for appropriate wall attachment hardware
• Attachment hardware
Note: This varies based on surface. For example, use 10 x 75 mm (3/8 x 3 in) lag bolts if
mounting on a wooden wall.
Inspect the Boxes for Correct Contents
The wall mount CT4000 ships in four boxes.
Important: Ensure the wall supports the station. If mounting to a hollow wall, bridge at
least two studs using a 41 mm (1-5/8 in) channel strut.
To Next Page
Loading...
