Check Point QUANTUM SPARK 1600 - Page 111

Configuring Local and Remote System Administrators
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|111
To create a local administrator:
1. Click New.
The Add Administrator page opens.
2. Enter the administrator details:
n
Name. The hyphen (-) character is allowed in the administrator name.
n
Password and then Confirm password.
Note - You cannot use these characters in a password or shared secret: { } [
] ` ~ | ‘ " \ (maximum number of characters: 255)
n
Email address.(Optional)
Note - In the R81.10.X releases, this feature is available starting from the
R81.10.05 version.
n
Phone number. (Optional)
Note - In the R81.10.X releases, this feature is available starting from the
R81.10.05 version.
3. Click Apply
The name and Administrator Role is added to the table. When logged in to the WebUI, the
administrator name and role is shown at the top of the page.
Note - Defining an email address and phone number is optional. However, you must have
either an email address or a phone number defined to:
n
Receive Security alert notifications by email or SMS. See "Notifications" on page42
n
To reset your password on the Login page of the WebUI (see below).
To edit the details of locally defined administrators:
1. Select the administrator from the table and click Edit.
2. Make the relevant changes.
3. Click Apply
To delete a locally defined administrator:
1. Select an administrator from the list.
2. Click Delete.
3. Click Yes in the confirmation message.
Note - You cannot delete an administrator who is currently logged in.
To reset password:
Note - In the R81.10.X releases, this feature is available starting from the R81.10.08 version.
You can securely reset your password when you log in to your Security Gateway.