Configuring Local and Remote System Administrators
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|112
Note - You must have an email address or phone number configured as part of the
administrator details.
1. In the Login page, enter the User Name and click Forgot my password.
2. The Find Your Account screen appears. Enter your Username and your Email or Phone number,
and click Next.
You receive a message with a security code (One Time Password).
3. Enter the security code and click Next.
4. Create and enter your new password in the applicable field.
Note - The password must contain a minimum of 6 characters.
5. In the Confirm password field, Enter the password again.
6. Click Next
7. A message on the screen confirms your password was successfully changed.
8. Click Next to proceed to the Login page.
Remote Administrators
To allow access for administrators defined in a remote RADIUS server:
1. Make sure administrators are defined in the remote RADIUS server.
2. Make sure a RADIUS server is defined on the appliance. If there is no server, click the RADIUS
configuration link at the top of this page. You must configure the IP address and shared secret
used by the RADIUS server.
3. When you have a configured RADIUS server, click Edit permissions.
The RADIUS Authentication window opens.
4. Select Enable RADIUS authentication for administrators.
Use roles defined on RADIUS server is selected by default.
5. Configure the role for each user on the RADIUS server. See additional details below.
Note - A user without role definition will get a login error.
6. If you select Use default role for RADIUS users, select the Administrators Role:
n
Super Admin
n
Read only
n
Networking Admin
n
Mobile Admin
7. To define groups, click Use specific RADIUS groups only and enter the RADIUS groups
separated by a comma.
8. Click Apply
To Next Page
Loading...
