Advanced Settings
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|150
Clarifications
This section contains clarifications for specific attributes.
Attribute Name Note
Two-Factor Authentication
- Enable selection of target
where to send the
passcode (SMS/email)
1. Select or clear the checkbox:
n
Cleared - The appliance sends the OTP by SMS and by
Email (this is the default).
n
Selected - After an end-user clicks "Connect" in their
Remote Access VPN client, in the next window the end-user
must enter a mobile phone number to get the OTP by SMS,
or enter an email to get the OTP by Email.
2. Click Apply
Note - This setting does not affect the selection screen in the WebUI
on the VPN Remote Access Control page. The user must still
configure to receive the passcode through email, SMS, or both
options.
All attributes, whose name
starts with "DSL globals"
When all the ADSL standards are turned off in the Advanced Settings,
and you can only connect using the VDSL2 standard, the VPI, the VCI,
and the encapsulation options still appear, even though they are not used
to open an Internet connection.
Changes Between Versions
This section describes changes in attributes in different R81.10.X versions.
Attribute Name Supported Versions
Dr. Spark job R81.10.08 and Higher
Fonic settings - Mode R81.10.08 and Higher
OS advanced settings - Enable automatic WiFi channel
change
R81.10.08 and higher
OS advanced settings - Enable GPS R81.10.07 and higher
OS advanced settings - Enable Jumbo Frames R81.10.07 and higher
USB Modem Watchdog - Enabled by Default R81.10.05 and higher
Smart Accel Settings - Accel Trusted Https Domains Only R81.10.05 and higher
Cluster - Synchronization R81.10.05 and higher
Smart Accel Services - Security logs enabled R81.10.05 and higher
Two-Factor Authentication - Enable selection of target
where to send the passcode (SMS/email)
R81.10.05 and higher
To Next Page
