Managing Internal Certificates
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|147
Upgrading a Cluster Manually
Procedure
Notes:
1. Only manual local upgrade is supported.
2. Upgrade each Cluster Member individually.
3. Start the upgrade on the Standby Cluster Member.
4. After the upgrade, the appliance automatically reboots and changes its cluster state to
Active.
5. Start the upgrade on the new Standby Cluster Member (former Active).
1. Upgrade the current Standby Cluster Member:
a. Connect to the WebUI on a Cluster Member:
https://<IP Address of the Cluster Member>:4434
b. From the left navigation panel, click Device.
c. In the Advanced section, click the High Availability page.
d. At the top of this page, examine the cluster state.
If the current cluster state shows "This gateway (<...>) is standby", then continue to the
next step.
Otherwise, connect to the other Cluster Member
e. In the System section, click the System Operations page.
f. Click Manual Upgrade.
The Upgrade Software Wizard opens.
g. Follow the wizard instructions.
h. Standby Cluster Member reboots automatically and changes its cluster state to Active.
2. Upgrade the new Standby Cluster Member (former Active Cluster Member):
a. Connect to the WebUI on the Cluster Member:
https://<IP Address of the Cluster Member>:4434
b. From the left navigation panel, click Device.
c. In the Advanced section, click the High Availability page.
d. At the top of this page, examine the cluster state.
Wait for the current cluster state to show "This gateway (<...>) is standby", and then
continue to the next step.
e. In the System section, click the System Operations page.
f. Click Manual Upgrade.
To Next Page
Loading...
