Configuring VPN
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|231
n
To see the currently connected Remote Users, go to VPN >Remote Access > Connected
Remote Users.
n
To see the current Remote Access VPN tunnels, go to Logs &Monitoring >Status >VPN
Tunnels.
n
To see the traffic from the currently connected Remote Access VPN users, go to Logs
&Monitoring >Logs >Security Logs (on the VPN> Remote Access >Blade Control
page, you must select Log traffic from Remote Access users).
Advanced options
For more information, see
"Configuring Advanced Remote Access Options" on page242
.
Changing the Default Remote Access VPN Port
Procedure
The default Remote Access VPN port is TCP 443. If you configured the WebUI on the appliance to work
on the TCP port 443 as well, a conflict message appears on the VPN > Remote Access > Blade
Control page.
If you enabled one of these Remote Access VPN clients:
n
Check Point VPN clients
n
Mobile client
n
SSL VPN
then you must change the default Remote Access VPN port:
1. Click the Change port link.
The Remote Access Port Settings window opens.
2. In the Remote Access port field, enter a new port number.
3. Select Reserve port 443 for port forwarding.
4. Click Apply.
To Next Page
Loading...
