Restoring Factory Defaults
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|326
n
Use the Bypass push button on the side of the 1595R appliance.
In Active mode, pressing the button for more than 5 seconds switches the mode to Force-Bypass.
In Force-Bypass mode pressing the button for more than 5 seconds, switches the mode to Active.
The Bypass LED indicates the current bypass status when power is on. When the LED is on, Bypass is
activated. If the LED is off, Bypass is off.
Note - When using the button to switch modes, the status will not be saved in the configuration
and the mode will switch back to the UI configured mode after a reset or power down.
When the mode is set to Active: After power is restored or after a reset, the appliance reboots and the
system maintains the bypass between the DMZ/LAN4 ports until the Security Policy is activated. Once the
Security Policy is activated, the system will set the Bypass to the mode configured by UI.
When the mode is set to Bypass: After power is restored or a hardware/software reset, the DMZ-LAN4 port
connection is still bypassed until you reconfigure the mode and the software system is valid.
Configuring Bypass mode in the WebUI
1. Go to Device >Advanced Settings.
2. In the search field, enter "fonic."
3. The Fonic settings - Mode attribute appears. Double-click the attribute name.
4. In the attribute window that opens, select or clear the checkbox to change the mode from Active to
Bypass mode.
5. Click Apply.
Configuring Bypass mode in Gaia Clish
To display the current (Fonic) Bypass configured mode:
show fonic-settings advanced-settings
To switch between Active and Bypass mode:
set fonic-settings advanced-settings mode
To Next Page
