Inspecting VoIP Traffic
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|178
Important - You cannot use Smart Accel and SSL Inspection at the same time.
Configuring Smart Accel in R81.10.05 and higher
Smart Accel for Services
To enable Smart Accel for Services
Note - Smart Accel for Services is enabled ("On") by default.
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Services, click the Off toggle.
Wait for the toggle to change to On.
3. To the right of the On/Off toggle, click the services link that appears in one of these sentences:
n
All services selected
n
X/Y services selected
The Smart Accel Services window opens.
By default, all the services are selected.
4. If it is necessary to inspect a service, then clear its checkbox.
If it is necessary to bypass the inspection for a service, then select its checkbox.
5. Click Apply
To disable Smart Accel for Services
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Services, click the On toggle.
Wait for the toggle to change to Off.
Smart Accel for Assets
Note - In the R81.10.X releases, this feature is available starting from the R81.10.05 version.
To enable Smart Accel for Assets
Note - Smart Accel for Assets is disabled ("Off") by default.
1. Go to the Access Policy view > Firewall section > Smart Accel page.
2. In the section Smart Accel Assets, click the Off toggle.
Wait for the toggle to change to On.
3. To the right of the On/Off toggle, click the assets link that appears in one of these sentences:
To Next Page
