Check Point QUANTUM SPARK 1600 - Revoking the Hotspot Access; To revoke the Hotspot access; Adding a New Network Object to Bypass SSL Inspection Based on the Host MAC Address

To Next Page

To Previous Page

Managing Active Devices

Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|45

Revoking the Hotspot Access

The display shows the devices connected to the gateway through a Hotspot.

You can revoke the Hotspot access for one or more devices.

This disconnects the device from the gateway and requires the device to log in again through the Hotspot.

To revoke the Hotspot access:

1. Click the record for the relevant device.

2. Click Revoke Hotspot Access.

The access for that device is revoked. You must log in again through the Hotspot to reconnect the

device to the gateway.

Notes:

This page is available from the Home and Logs & Monitoring tabs.

If there is no IPv6 activity in a dual stack host, the Active devices do not show the IPv6

address.

Adding a New Network Object to Bypass SSL Inspection

Based on the Host MAC Address

1. Click the device to select it.

2. From the toolbar, click Save as and select Device type Network Object.

3. For Host MAC address, enter a custom value or select from the menu.

4. Select Bypass host with this MAC by SSL inspection.

5. In Object name, enter the applicable text.

6. Click Apply

Note - You can also do this from the Users & Objects > Network Objects page. Click New, and

then for Type, select Device.

Other manuals for Check Point QUANTUM SPARK 1600