Configuring the Routing Table
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|131
Adding a Specific IPv4 Static Route
This procedure adds a specific static route to send traffic from any source, to any destination, for any
protocol to a specific IPv4 address.
Procedure
1. From the left navigation panel, click Device.
2. In the Advanced Routing section, click the Routing Table page.
3. Above the routing table, click New.
The New Static Routing Rule window opens.
4. In the Destination column:
n
To route traffic to any destination, leave the default value Any
n
To route traffic to a specific IPv4 address:
a. Click the value Any.
b. Select Specified IP Address.
c. Configure the required IP Address.
d. Configure the required Subnet Mask.
e. Click OK.
5. In the Source column:
n
To route traffic from any source, leave the default value Any
n
To route traffic from a specific IPv4 address:
a. Click the value Any.
b. Select Specified IP Address.
c. Configure the required IP Address.
d. Configure the required Subnet Mask.
e. Click OK.
6. In the Service column:
n
To route traffic for all services (protocols), leave the default value Any
n
To route traffic for a specific service:
a. Click the value *Any.
b. Select the required service object or a service group object.
Notes:
l
You can select only one service object or one service group object.
l
In the bottom right corner, you can click New > Service, or Service
group to create a custom service or a group of services.
c. Click OK.
7. In the Next Hop column:
To Next Page
