Advanced Threat Prevention Engine Settings
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|205
Advanced Threat Prevention Engine Settings
In the Threat Prevention > Threat Prevention Engine Settings page you can configure advanced
configuration settings for the Anti-Virus, Anti-Bot, Threat Emulation, and IPS engines.
Note - Many of the configurations below are advanced and should only be used by experienced
administrators.
IPS
Configure the settings for newly downloaded protections:
n
Active
n
Detect
n
Inactive
To enable Detect-only mode:
Select the checkbox.
To import IPS protections:
Click the link.
Anti-Virus
Anti-Virus scans incoming files for viruses.
The mail settings include:
n
SMTP - Simple Mail Transfer Protocol is a communication protocol for electronic mail transmission.
n
POP3 - Uses the POP3 protocol to send and receive emails with TLS encryption.
n
IMAP - Internet standard protocol used by email clients to retrieve email messages from a mail server
over a TCP/IP connection. It allows you to access your email from any device.
To enable POP3S or IMAP scans:
1. On the Threat Prevention > Engine Settings page, under Anti-Virus Scanned protocols, select the
Mail (SMTP, POP3 and IMAP) checkbox.
2. On the Access Policy > SSL Inspection Policy page, select the checkbox to enable SSL traffic
inspection.
3. Under Protocols to inspect, select POP3S or IMAP.
4. Click Apply
To Next Page
Loading...
