Check Point QUANTUM SPARK 1600 - Cluster Managed by Quantum Spark Portal

Managing Internal Certificates
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|148
The Upgrade Software Wizard opens.
g. Follow the wizard instructions.
h. This Standby Cluster Member reboots automatically and keeps the cluster state Standby.
Cluster Managed by Quantum Spark Portal
Procedure
You can configure a cluster in which both gateways are managed by Quantum Spark Portal.
Make sure the gateways are connected to Quantum Spark Portal before you configure the cluster.
A cluster supported by Quantum Spark Portal is very similar to a Locally Managed cluster. One member
is Active, and the other is Standby. To change the status of the Active member, click Force Member
Down.
The configuration procedure is the same as for the Locally Managed cluster:
1. See "Limitations" on page139 .
2. See "Prerequisites" on page139 .
3. Follow "Configuring a Primary Cluster Member" on page141 .
4. Follow "Configuring a Secondary Cluster Member" on page142 .
Important - When you manage the cluster in Quantum Spark Portal, the cluster does not
synchronize connections. In the event of a cluster failover, you must re-establish the
connections.