Check Point QUANTUM SPARK 1600 - Harmony Connect

Harmony Connect
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|247
Harmony Connect
Note - In the R81.10.X releases, this feature is available starting from the R81.10.05 version.
From your Quantum Spark Appliance, you can set up a VPN connection with Harmony Connect to provide
security and other services for your Security Gateway.
You must enable the IKEv2 Key Type for FQDN in "Advanced Settings" on page149 first.
To establish a connection from your appliance with Harmony Connect:
1. In the VPN Site to Site page, select one of these options to activate Harmony Connect:
n
Create a new VPN site which creates a new instance of a VPNsite inside Harmony Connect
and then creates tunnels to establish the connection.
n
Connect to an existing VPN site and create the tunnels.
Enter the required information and click Apply. The activation details are supplied by your
Harmony Connect provider.
2. Follow the steps to establish the connection. This may take a few minutes.
For more information on how to set up this connection, see the Harmony Connect Administration Guide and
the Harmony Connect for SMB Gateways Integration Guide .