Configuring Threat Prevention Policy Exceptions
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|200
To enable the Horizon SOC feature in the WebUI:
1. Click Device > Advanced Settings.
2. In the Privacy Settings Attribute section, select the attribute Help Check Point improve its products
by sending data.
a. Click Edit.
b. Select Help us improve product experience by sending data to Check Point.
c. Click Apply
3. In the Threat Prevention Policy Attribute section, select the attribute Allow me to view attack
statistics in my User Center account.
a. Click Edit.
b. Select Allow me to view attack statistics in my User Center Account.
c. Click Apply
4. Optional: In the Threat Prevention Policy section, select the attribute Allow IP address information
in attack statistics.
a. Click Edit.
b. Select Allow IP address information in attack statistics (see sk164332 - section "De-
obfuscate the real IP of the victim").
c. Click Apply
To enable the Horizon SOC feature in Gaia Clish:
1. Allow the appliance to send data to Check Point:
set privacy-settings advanced-settings customer-consent true
2. Allow viewing attack statistics in your User Center Account:
set threat-prevention policy advanced-settings allow-attack-stats true
3. Optional: Enable the real IP address information in the attack reports (see sk164332 - section "De-
obfuscate the real IP of the victim"):
set threat-prevention policy advanced-settings allow-ipaddr-in-stats true
To Next Page
