Check Point QUANTUM SPARK 1600 - Page 283

Managing Authentication Servers
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|283
To edit an Active Directory domain
1. Click the Users & Objects view > Users Management section > Authentication Servers page.
2. In the section Active Directory section, select the Active Directory domain.
3. Click Edit.
4. Make the applicable changes.
You cannot change the Domain.
5. Click Apply
To delete an Active Directory domain
1. Click the Users & Objects view > Users Management section > Authentication Servers page.
2. In the section Active Directory section, select the Active Directory domain.
3. Click Delete.
4. Click OK in the confirmation message.
To change synchronization mode with the defined Active Directories
1. Click the Users & Objects view > Users Management section > Authentication Servers page.
2. In the section Active Directory section, click Configure.
3. Select the applicable option:
n
Automatic synchronization
n
Manual synchronization
Note - With this option, you can synchronize the user database known to the
appliance in all locations that this user database can be viewed.
For example:
l
The Users & Objects view > User Management section > Users page.
l
The Access Policy > view > Firewall section > Policy page > Source
picker.
You cannot select a user from the Active Directory, only an Active Directory
user group.
You can select a local user.
4. Click Apply