Configuring Cloud Services
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|39
To connect to Cloud Services:
1. Click Configure or Edit.
The Configure Cloud Services window opens.
2. Select Activation key or Activation details and enter the specified information.
3. Click Apply
The appliance tries to connect to the Cloud Services Provider. The Cloud Services section shows a
progress indicator and shows the connection steps.
Note - If you see a message that the identity of your Cloud Services Provider cannot be verified
but you are sure of its identification, click Resolve and then Ignore and reconnect.
When connectivity is established, the Cloud Services section at the top of the page appears:
n
The date of the synchronization
n
The On/Off toggle shows that Cloud Services is turned on.
A Cloud Services Server widget appears on the status bar and shows Connected. If you click this widget,
the Cloud Services page opens.
To test connectivity to the Cloud Services:
1. Connect to the command line on the appliance.
2. Log in to the Expert mode.
3. Run this command:
runCliCommand.lua testcloudconnectivity [<IP Address or FQDN>]
To get an updated security policy, activated blades, and service settings:
Click Fetch now.
The appliance gets the latest policy, activated blades, and service settings from Cloud Services.
To Next Page
Loading...
