Managing the Device
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|67
To select an active image for a SIM:
1. In Device > Internet, double click an existing cellular connection, or select the connection and click
Edit. You can also click New to create a new cellular connection.
The Edit Internet Connection window opens.
2. In the Cellular tab, for each SIM, select the new Carrier configuration package from the list of
supported image package names. Each SIM can have a different carrier.
Note - This list dynamic, based on the valid installed packages on the modem.
3. Click Apply
On the Internet page, the Status changes to Connecting with the message:
Switching carrier configuration package. This may take a few minutes.
To disable image switching:
In the Cellular tab, for each SIM, select None for the Carrier configuration package.
n
For PPPoE over ATM over VDSL/ADSL or IPoE over ATM over VDSL/ADSL or for an ADSL
interface:
l
Enter the VPI number and VCI number you received from your service provider, and the
Encapsulation type (LLC or VC_MUX).
n
For WAN/DMZ interfaces and static, DHCP, PPPoE, PPTP, and L2TP connection types
or
For VDSL/ADSL interfaces and IPoE - dynamic IP and IPoE - static IP connection types over PTM:
l
Use connection as VLAN - Select this checkbox to add a virtual Internet interface.
l
VLAN ID - Enter a VLAN ID between 1 and 4094.
To Next Page
Loading...
