Check Point QUANTUM SPARK 1600 - Page 72

Managing the Device
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|72
n
Connection - Name. For example, Internet1.
n
Server Name
n
IP address
n
Packet Loss
n
Failures
n
Avg. Latency
n
Min Latency
n
Max Latency
n
Jitter
Probing provides information about the quality of an internet connection and what action to take if there is no
connectivity. You can configure separate probing settings for each internet connection.
To configure probing for an internet connection (pings):
1. In the Internet Connectivity page, select a connection and click Connection Monitoring.
The Edit Internet Connection window opens.
2. In the Connection Monitoring tab, select Monitor connection state by sending probe packets to
one or more servers on the Internet.
Select this option to use more methods and servers to detect connectivity loss.
3. For Connection probing method, select ping addresses.
4. Under Advanced Probing Settings, use the default values or enter new ones for:
n
Recovery time (in seconds)
n
Max latency allowed (milliseconds)
n
Probing frequency (seconds)
n
Window size (pings)
n
Failover pings (percent failures)
5. Click Apply.
To monitor a connection by DNS probe:
1. In the Connection Monitoring tab, select Monitor connection state by sending probe packets to
one of more servers on the Internet.
2. For Connection probing method, select DNS probe.
3. Click Apply.