Chemyx Fusion Series - Chemyx Pump Controller Programs

51
Chemyx, Inc.
Fusion Series User Manual
hexw2 0 1 23.04 2.4
save setting
Deprecated command.
set primerate X
Sets the priming/bolus rate (Basic Mode only).
X must be an integer or decimal (up to five decimal places)
within the rate limits for the syringe (See read limit parameter
command).
Only one value is required.
Example
set primerate 1.0
Returns the priming/bolus rate (in Basic Mode).
restart
Powers off and then automatically powers on the pump.
In some cases, depending on the software used to connect to the pump, each command may
need to be followed by a line feed character such as “\n” or “\r” to execute. If a command does
not appear to work, try adding “\r” or “\n” to the end of the line.
Example
set units 1 \r
When the pump does not recognize a command, it will return text similar to the following:
Example
Command not recognized-type in "help"
and press enter to see a command list.
Chemyx Pump Controller Programs
In addition to the manual control of the pumps through a terminal, Chemyx provides pump
controller programs as an unsupported open-source applications written in Python, a LabVIEW
package, and a MATLAB package. More information on these tools can be found on the website
at www.chemyx.com/support.