Chison ECO 2 - Page 113

ECO 2 Ultrasound Diagnostic System
Page 104 / 189
2. Input name into the new created annotation status box, move the cursor to the [Create] button
then press [ENTER], then create new annotation status and appear in selected annotation status
list.
3. Move the cursor to the [Delete] button, press [ENTER], then delete current annotation status in
the selected annotation list.
4. Alter name of current annotation status list in [Current Type Name] input box, press [ENTER]
on the [Rename] button, then rename the selected annotation status name.
NOTE:
Factory Settings comments cannot be deleted or renamed.
7.3.2 Edit Comment
Operator uses only current annotation instead of all content annotation status provides inlay
common annotation. If necessary, user can import annotation or self-compiled annotation into
common annotation.
7.3.2.1 Add comment from comment library
Operation:
1. Select needed source annotation status via Trackball and [ENTER].
2. Select needed annotation at [Comment Lib] column then press [ENTER] to activate this
annotation.
3. Press [ENTER] on [>] button to import selected annotation into user-selected annotation status;
press [ENTER] on [>] button to move selected annotation in [Comment Selected] column into
source annotation.
4. Press [ENTER] on [>>] button to import all annotation in source into user-selected annotation
status; Press [ENTER] on [>>] button to move all annotation in [Comment Selected] column into
source annotation.
7.3.2.2 Add comment manually
Operation:
1. Activate [Edit Comment] input box via Trackball and [ENTER] button, and then input needed
abbreviation and full name of annotation.
2. Press [ENTER] on [Add] button, meanwhile this handout will be added into source and
user-selected annotation status.