ECO 2 Ultrasound Diagnostic System
Page 47 / 189
5.6.2 Dynamic
Dynamic range is used for adjusting the contrast resolution of B mode image and mode image,
compressing or enlarging the display range of gray scale.
At the real-time status, press the first line button of [Dynamic] to increase the Dynamic, and press
the second line button of [Dynamic] to decrease the Dynamic. The range is 30 to 90.
5.6.3 i-Image
In real status, press the corresponding button of [i-Image] to adjust, the range is 0~3.
5.6.4 Compound
In real status, press the corresponding button of [Compound] to adjust, and the range is 0~3.
The SRA can’t be edited after opening the compound.
5.6.5 SRA
In real status, press the corresponding button of [SRA] to turn on or off.
5.6.6 PW
Display PW mode.
5.6.7 M Speed Adjustment
In real M status, press the corresponding button of [Speed] to adjust M speed.
5.6.8 Gain
In real status, rotate [GAIN] button to adjust the Gain, and the range is 0~255, the step is 5.
5.6.9 STC
STC curves can be used for adjusting gain compensation in different image depth.
Drag the slide of STC to adjust the value.
STC curve will disappear automatically 1 second later after stopping adjustment.
5.6.10 Depth
Press [DEPTH/FOCUS] selection knob until the indicator of [DEPTH] is lit, and then rotate the
knob to change the depth of image.
5.6.11 Focus Position
Press the [DEPTH/FOCUS] selection knob until the indicator of [FOCUS] is lit. Then turn the knob
To Next Page
Loading...