Chison ECO 2 - Page 135

ECO 2 Ultrasound Diagnostic System
Page 126 / 189
 Inspect probes for sharp edges or rough surfaces that may injure sensitive tissue.
 DO NOT apply excessive force to the probe connector when inserting into the probe port. The
pin of a probe connector may bend.
 Special handling instructions
Using protective sheaths
The use of market cleared probe sheaths is recommended for clinical applications. Reference
FDA March 29, 1991 "Medical Alert on Latex Products".
Protective sheaths may be required to minimize disease transmission. Probe sheaths are
available for use with all clinical situations where infection is a concern. Use of legally marketed,
sterile probe sheaths is strongly recommended for endo-cavitary procedures.
DO NOT use pre-lubricated condoms as a sheath. In some cases, they can damage the probe.
Lubricants in these condoms may not be compatible with probe construction.
Devices containing latex may cause severe allergic reaction in latex sensitive individuals. Refer to
FDA’s March 29, 1991 Medical Alert on latex products.
DO NOT use an expired probe sheath. Before using a sheath, verify if it has expired.
Endocavitary Probe Handling Precautions
If the sterilization solution comes out of the endocavitary probe, please follow the cautions below:
Sterilant Exposure to Patient (e.g., Cidex): Contact with a sterilant to the patient’s skin for
mucous membrane may cause an inflammation. If this happens, refer to instruction manual of the
sterilant.
Sterilant Exposure from Probe handle to Patient (e.g. Cidex): DO NOT allow the sterilant to
contact the patient. Only immerse the probe to its specified level. Ensure that no solution has
entered the probe’s handle before scanning the patient. If sterilant comes into contact with the
patient, refer to the sterilant’s instruction manual.
Sterilant Exposure from Probe connector to Patient (e.g. Cidex): DO NOT allow the sterilant
to contact the patient. Only immerse the probe to its specified level. Ensure that no solution has
entered the probe’s connector before scanning the patient. If sterilant comes into contact with the
patient, refer to the sterilant’s instruction manual.
Endocavitary Probe Point of Contact: Refer to the sterilant’s instruction manual.