ECO 2 Ultrasound Diagnostic System
Page 134 / 189
according to the manufacturer’s instructions.
2. Place the cleaned and dried probe to contact with the germicide, being careful not to let the
probe drop to the bottom of the container and thus damage the probe.
3. After placing/immersing, rotate and shake the probe while it is below the surface of the
germicide to eliminate air pockets. Allow the germicide to remain in contact with the fully immersed
probe. For high level disinfection, follow the manufacturer’s recommended time.
4. Following all precautions for storage, use and disposal, prepare the germicide solution
according to the manufacturer’s instructions.
5. After removing from the germicide, rinse the probe according to the germicide manufacturer’s
rinsing instructions.
6. Flush all visible germicide residues from the probe and allow to air dry.
9.4 Service Responsibility
If users install, use and maintain the system fully according to CHISON’s installation manual,
operation manual and service manual, then CHISON ECO main unit has a life time of 5 years and
CHISON ECO probes have life time of 5 years after ex-work.
The warranty of the system and probes after ex-work is as the time in the warranty card.
The system is a precise electronic system. Only the CHISON’s authorized service engineer could
replace the defective parts. Any assembly, disassembly, handling, repair, or replacement by any
other people may have adverse impact on the safety and effectiveness of the systems and probes,
and thus will reduce the life time of the system and probes, and such systems and probes will not
be covered by CHISON warranty after the above improper handling. Standard maintenance must
be performed by CHISON’s authorized service engineer during the life time of the product.
To Next Page
Loading...