ECO 2 Ultrasound Diagnostic System
engineers, CHISON shall not be liable for the system.
8. The purpose of this system is to provide physicians with data for clinical diagnosis.
It is the physician’s responsibility for diagnostic procedures. CHISON shall not be
liable for the results of diagnostic procedures
9. This manual contains warnings regarding foreseeable potential dangers, but user
shall always be alert to dangers other than those indicated as well. CHISON shall not
be liable for damage or loss that results from negligence or from ignoring the
precautions and operating instructions described in this operation manual.
10. Due to negligence not following operation manual, CHISON shall not be liable for
the results.
11. Each time before and after ultrasound examination, please check the probe
surface, probe cable and sheath whether they are abnormal, such as cracking,
peeling and deformation. Also check whether the lens is strongly fixed. Abnormal
probes may cause electric shock and injure the patient. Once any abnormal, user
must stop using and contact CHISON's authorized service engineer.
12. If the probe is dropped or scratched by hard part, please stop using the probe
immediately. And contact CHISON's authorized service engineer to make sure the
safety and effectiveness is in good condition before use.
13. If there is any liquid or metal to enter to the system, please power off the system
and stop using it immediately. Please first contact CHISON’s authorized service
engineer to make sure it’s safe before restart using it.
14. Please don't use solvents (such as paint thinner, benzine, or alcohol) or abrasive
cleansers for cleaning the system (including monitor and probes, etc.). It may corrode
the system and probes.
15. While the system or probe is over life time, please refer to operation manual
section 9.4
16. Important data must be backed up on external memory media. CHISON shall not
be liable for loss of data stored in the memory of this system caused by operator error
or accidents.
17. Please put this operation manual with the system to ensure operator and
To Next Page
Loading...