ECO 2 Ultrasound Diagnostic System
Page 54 / 189
2. Move the cursor to the position where need to comments.
3. Input characters at cursor position by keyboard then press [ENTER] key to confirm.
4. Press again to exit. The will light off and the comments process is finished.
5.10.3 Input Comment Library Characters
1. In comment status, move trackball to image area to edit;
2. Press [Font size] to adjust front size of comments, the range is 10~20;
3. Rotate [MENU] to select needed comments, then press [MENU] to exit ;
5.10.4 Edit Quick Comments
1. Press [Edit] to pop quick comment edit box;
2. Input customized comments;
3. Press [Done] to finish edit, press [X] to cancel edit;
5.10.5 Input Quick Comments
1.Press [Text] to select needed quick comments;
2.Adjust front size of comments;
3.Press [Input] to place comments in the image area;
5.10.6 Move Comments
1. In comment status, move trackball to the comment, press [ENTER] to activate it;
2. Move trackball to place the comment to target area;
3. Press [ENTER] again to confirm the comment;
5.10.7 Edit Comments
1. In comment status, move trackball to the comment, press [ENTER] to activate it
2. Press [BACKSPACE] to delete unnecessary characters;
3. Press [ENTER] to confirm;
5.10.8 Delete Comments
5.10.8.1 Delete Characters
In comment status, activate the comment that need to be deleted, then press the [ENTER], it will
display "|" on the screen, press [BACKSPACE] to delete the character.
5.10.8.2 Delete Single Comment
Activate the comment that needs to be deleted, press [DEL] to delete comment;
To Next Page
Loading...