ECO 2 Ultrasound Diagnostic System
Page 63 / 189
2. During the measurement, [UPDATE] is used to switch the start point and end point, long axis
and short axis when the measurement is not finished.
3. During the distance measurement, press the [ENTER] to fix the start point, when the end point
is not fixed, press [UPDATE] to switch the start point and end point.
4. During the Ellipse measurement, when fix the long axis, but the short axis is not fixed, press
[UPDATE] to switch the long axis and short one.
6.1.4 [DEL]
Main functions are as follows:
In frozen status, press [DEL], delete all the measurement results, comments and traces.
6.1.5 [Change]
Press [Change] to switch other menu;
6.1.6 [Exit]
Press [Exit] to exit the measurement menu.
6.1.7 Parameters control button
Press the corresponding button to update the function and use the function.
6.2 B Mode general Measurement methods
The system B mode contains Distance, Ellipse, and Trace.
6.2.1 Meas. Distance
Measurement steps:
1. Press the [Calc] button to enter into measurement. Update the [distance] item in the menu or
press the quick measure button [Dist]; it will display a segment “+”icon.
2. Move the “+”icon by trackball to fit the one point of the line. Press [ENTER] to fix the start point
and the cursor can be moved to the next position.
3. Press [UPDATE] can change the activated point, and fit the other point of the line.
4. Move the cursor to the end-point, press [ENTER] again to complete the measurement.
5. After the measurement, the result will display in the measurement results area.
6. Repeat the steps from 1~4 to start next “distance” measurement. Press [DEL] to delete all the
measurements.
NOTE:
Each group of measurement is limited, if the measurement results beyond, it will begin a new
To Next Page
Loading...