Circutor CVM-C11-ITF-IN-485-ICT2 - Page 20

Table 8: Measuring parameters of the CVM-C11 (2-2Ph installation).
Parameter
2-2Ph
L1 N L12 III ∑ MAX MIN
Voltage -  M - - M M
THD Voltage M - - - - - -
Voltage harmonics M - - - - - -
Current M - - - - M M
THD Current M - - - - - -
Current harmonics M - - - - - -
Frequency M - - - - M M
Active power C - - - C C C
Apparent power C - - - C C C
Inductive Reactive Power - Consumption C - - - C C C
Inductive Reactive Power - Generation C - - - C C C
Capacitive Reactive Power -Consumption C - - - C C C
Capacitive Reactive Power - Generation C - - - C C C
Cos φ C - - C - C C
Power factor C - - C - C C
Maximum Current Demand C - - C - C -
Maximum Demand of Active power
- - - - C C -
Maximum Demand of Apparent Power
- - - - C C -
Maximum Demand of inductive Reactive Power
- - - - C C -
Maximum Demand of capacitive Reactive Power
- - - - C C -
Table 9: Measuring parameters of the CVM-C11 (2-1Ph installation).
Parameter
2-1Ph
L1 N III ∑ MAX MIN
Voltage M  - - M M
THD Voltage M - - - - -
Voltage harmonics M - - - - -
Current M - - - M M
THD Current M - - - - -
Current harmonics M - - - - -
Frequency M - - - M M
Active power C - - C C C
Apparent power C - - C C C
Inductive Reactive Power - Consumption C - - C C C
Inductive Reactive Power - Generation C - - C C C
Capacitive Reactive Power -Consumption C - - C C C
Capacitive Reactive Power - Generation C - - C C C
Cos φ C - C - C C
Power factor C - C - C C
Maximum Current Demand C - C - C -
20
CVM-C11
Instruction Manual